Does The "Transition Layer Count" Setting In Chitubox Actually Do

Transition Layer Count Chitubox. CHITUBOX SLA/DLP/LCD 3D Slicer Software Transition layers as I understand it isn't in addition to the base layers, but rather a modulation effect of lowering the exposure gradually from base to your normal layer exposure values through whatever layer and time value you set. What happens is that if the difference between bottom layer exposure and regular layer exposure is too big, the regular layers do not attach properly to the bottom layers.

If you see the setting on your Chitubox, there is this thing called " Transition Layer Count." For you who don't know what this setting means, I'll explain it to you today When transition layer compensation and bottom tolerance compensation are both enabled, the print result may be not be as good as expected

Transition layers on Chitubox? I’m having trouble getting rid of the

Transition time decrement This value is automatically calculated by Chitubox ChiTu Systems will continue to upgrade its firmware and more printers will support transition layer function. When transition layer compensation and bottom tolerance compensation are both enabled, the print result may be not be as good as expected

CHITUBOX SLA/DLP/LCD 3D Slicer Software. Bottom Tolerance Compensation only applies to bottom layers Enabling both layer transition and Bottom Tolerance compensation can lead to unexpected printing results.

ChiTubox Best Support Settings For Resin Printing 3DprintingGeek. It is basically the interval of seconds that the transition layers change per layer Image Blur Pixel : 2 ~ 8 , determines the number of pixels for edge transition, the higher level you select, the softer edge would be